Advertisement
Quick Links
Advertisement
Summary of Contents for NCR 7409-K400
- Page 1 7409‐K400 CD/DVD ROM Drive Kit Instructions Issue A...
-
Page 2: Revision Record
Revision Record Issue Date Remarks Jan 2009 First issue... - Page 3 Introduction This kit provides an integrated CD/DVD ROM Drive for the 7409. CD/DVD Bracket 497-0463593 Screw, M2 x 2.4 - 2.7mm, Phillips, Pan Hd 006-8611076 DVD SATA and Power Cable SATA DVD ROM Drive 497-0455758 006-8614321 26958...
-
Page 4: Installation Procedures
Installation Procedures Warning: Disconnect the AC power cord before disassembling the Terminal. 1. Remove the Display Head from its mount. Removing the 7409 from the Table Top Mount a. Release the Mounting Plate Latches and tilt the display back. Relock the latches. Mounting Plate Latches 26901 b. - Page 5 c. Disconnect the cables from the I/O Panel. Terminal Power Cable Printer USB Cable Keyboard USB Cable 26445a d. Release the Mounting Plate Latches and remove the 7409 from the mount. Mounting Plate Latches Baseplate 26659...
- Page 6 Removing the 7409 from the Fixed Angle Mount a. Remove the screws (2) in the sides of the Fixed Angle Mount. Screw (One on each side) 26681...
- Page 7 b. Rest the bottom of the display on the Display Support. Cable Cover Captive Screw Display Support 26680 Note: Place the Display Support behind the extension on then Display Hinge Bracket. Bracket Extension Display Support 24753 c. Loosen the captive screw that secures the Cable Cover and remove the cover.
- Page 8 d. Disconnect the cables from the I/O Panel. Note: The Power Cable connector locks into position when connected to the terminal and cannot be removed by simply pulling on the cable. You must grasp the connector and slide the outside housing out from the terminal to unlock it from the terminal connector.
- Page 9 Remove the display from the Fixed Angle Mount. 24629 g. Disconnect the Power Cord from the I/O Panel on the terminal. 2. Lay the terminal face down on a flat surface. 3. Loosen the captive screws (2) that lock the Rear Cover. Rear Cover Captive Screws 26903...
- Page 10 4. Pivot the Rear Cover to the open position. 5. Connect the DVD SATA and Power Cables to the Motherboard. 6. Install the drive. a. Fold the cables under the CD/DVD ROM Drive as shown below. b. Insert the two extensions on the CD/DVD RPM Bracket in the two slots in the chassis. c.
- Page 11 26957a Installed CD/DVD ROM Drive 7. Replace the Rear Cover and mount the Display Head to its mount using the reverse procedures. 8. Close the Rear Cover and replace the Display Head to its mount using the reverse procedures.
- Page 12 Accessing the DVD The DVD is accessed by removing the Access Cover on the side of the display (1 screw). Access Cover CD/DVD ROM Drive 26959...