User Menu; Thermostat Operation - Rinnai Brivis 1F83C-11PRBR Installation Manual

USER MENU

USER MENU
To customize thermostat settings, press the Menu button from the home screen. Use the
or buttons to highlight Settings and press Next. Use Next and Back to navigate
through menu items. Press
User's Menu #
(Press Menu button
and release)
01
02
03
04
05
06

THERMOSTAT OPERATION

THERMOSTAT OPERATION
Set Current Time and Day
Note: Time icons will flash at initial power up or after a reset.
1.) Press Set Time
2.) Use
or to adjust the hour
3.) Press Next to advance to set the minutes and day of the week
4.) Press Exit when finished.
The default program is 5-1-1 Day, but can be setup as a 7-Day or Non-Programmable
thermostat (refer to the User Menu above)
• Hold Temperature (bypassing the schedule) – With the System switch set to Heat or
Cool, momentarily press the Hold button. Hold will be displayed. Use
the temperature. The thermostat will hold the room temperature at the selected setting
until you press Run to start program operation again.
• Program Override (Temporary Hold) – Press
displayed. The thermostat will override the schedule until the next programmed time
period with a minimum override of 2 hours. Then the thermostat will automatically revert
to the program.
• Keypad Lockout – To prevent unwanted changes, the buttons can be disabled. To turn
this feature On, press and hold
Off, press and hold
Brivis
or to change the setting.
Description
Schedule Type (set as either 7-Day,
5-1-1 Day or Non Programmable)
Early Start (starts heating or
cooling early so your programmed
temperature is reached by the
programmed time)
Fahrenheit or Celsius
Temperature Display Adjustment
(adjust the Room Temperature)
Continuous Display Light (keep
the backlight always on – "C" wire
required)
Change Air Filter (set up a monthly
reminder)
and the Menu button until the
and the Menu button for 3 seconds.
Default Setting
(flashing icons)
5
OFF
°F
0
OFF
OFF
or until the desired temperature is
9
Settings
or )
(Press
7 – 7 Day
5 – 5-1-1 Day
0 – Non-programmable
On – start early
OFF – start at program
period time
°F – Fahrenheit
°C – Celsius
-5 to +5°F
On – always on
OFF – momentarily
1 to 12 – reminder time
(months)
OFF – no filter reminder
or to adjust
icon appears. To turn
DGH Manual Controller IM