Table of Contents
Advertisement
COLD WEATHER OPERATION
80
75
•
When the ambient temperature is low, the capacity of the battery considerably drops. Cover it, or remove it
from the machine to place it in the warm place. Restore it again before the operation.
•
If the electrolyte level is low, add distilled water in the morning before beginning the work. Do not add water
after the day's work to prevent diluted electrolyte in the battery from freezing during the night.
PRECAUTIONS AFTER DAILY WORK COMPLETION
Performing idling of the tracks is dangerous, stay well away from the tracks.
If such as mud or water which has stuck to the undercarriage freezes, the machine may not move in the next
morning. To prevent this, observe the following precautions.
•
Remove all the mud and water from the machine body. In particular, wipe the hydraulic cylinder rods clean
to prevent the seal from being damaged by mud or dirt together with drops of water on the rod which en-
tered inside the seal.
•
Place the machine on a firm, dry ground.
If this is impossible, park the machine on boards.
The boards prevent the tracks from freezing to the ground, and allow the machine to move the next morn-
ing.
•
Open the drain valve and drain any water collected in the fuel system to prevent it from freezing.
•
Fill up the fuel tank. This minimizes moisture condensation in the tank when the temperature drops.
•
After operation in water or mud, remove water from undercarriage as described below to extend undercar-
riage service life.
•
Do not leave the machine running idle for a long time. The inside of KCCV and blowby piping may freeze
solid and block the piping.
To prevent freeze, stop the engine or, if it is necessary to run the engine at idle, apply the load from time to
time.
•
Do not continue low-load operation . If continuous low-load operation is performed, operate the machine
with load (warm-up operation) before stop the engine.
AFTER COLD WEATHER SEASON
When the season changes and the weather becomes warmer, do as follows.
Replace the fuel and oil for all equipment with the ones of the specified viscosity. For details, see "METHOD
FOR USING FUEL, COOLANT AND LUBRICANTS ACCORDING TO AMBIENT TEMPERATURE".
3-238
1.24
1.25
1.26
1.23
1.24
1.25
k
k
1.27
1.26
WARNING
OPERATION
Advertisement
Chapters
Table of Contents
