Configuring The Printer For The Network With The Control Panel - Xerox 4151 Printer Reference

2. Configuring the Printer for
Configuring the Printer for the Network
with the Control Panel
After installing the optional Network
Interface Board, configure it for the
network using the printer's control
panel.
If you use TCP/IP, you should assign
the IP Address and Subnet Mask. You
can also set the Gateway Address us-
ing the printer's control panel.
Note
❒ When you turn the machine's pow-
er switch on, it may take a few
minutes to initialize the optional
Network Interface Board. If the "2.
Network Setup" in the following
step 4. is shaded, wait for a few
minutes.
Reference
For more information about using
this machine as a network printer,
see the "Quick Configuration
Guide" which is provided as a PDF
file on the CD-ROM labeled "Op-
erating Instructions for Printer".
A A A A
Press { { { { User Tools/Counter} } } } .
Dial
k Dial
se/
ial
the Network
B B B B
Press the 0 0 0 0 or 1 1 1 1 key until the fol-
lowing message appears on the
panel display.
C C C C
Press { { { { OK} } } } .
The following screen appears on
the panel display.
D D D D
Press the 0 0 0 0 or 1 1 1 1 key until the fol-
lowing message appears on the
panel display.
E E E E
Press { { { { OK} } } } .
The following screen appears on
the panel display.
F F F F
Press { { { { OK} } } } .
The following screen appears on
the panel display.
ZENS058E
13