Front Derailleur - Cannondale FLASH 2010 Owner's Manual Supplement

160 mm ADAPTER (CARBON)
Two Cannondale designed post mount adapters enable
installation of 160 mm brake rotors.

FRONT DERAILLEUR

SRAM S3 / SHIMANO E-TYPE w/o plate
FD
KP135/ - SRAM 160mm
SRAM S2
FD
KP123/
CHAINPLATE
FD
REAR DERAILLEUR HANGER
Before re- installing (same or new): Clean dropout and inspect
carefully for any cracks or damage. Clean surfaces and apply a
light film of bike grease to the dropout to minimize any noise
or "creaking" that might result from very slight movement
between the dropout and hanger during movement of
the derailleur. Apply grease and Loctite carefully. Do not
contaminate the male or female bolt threads with grease
which would cause the Loctite to be ineffective.
KP121/
KP048/
Check derailleur adjustment after replacement. Readjust
wheel quick release so it is very tight. See PART I Section 4. A
in your Cannondale Bicycle Owner's Manual.
NOTICE
Do not use a derailleur hanger alignment tool to straighten.
15
125238.PDF
2.5 mm
s