Main Board Block - Sony SRF-18 Service Manual

SRF-18
1-3.

MAIN BOARD BLOCK

knob
(power)
Note: When installing the knob (power),
the position of switch (S501) and
claw of knob (power) is set and installed.
2 knob (power) block
3 Peel off the transparent plate
from adhesive sheet.
4 transparent plate
Note: When installing the transparent plate, the position of
convex part and ditch is set and installed.
qa MAIN board block
0 Lift up the MAIN board block
in the direction of an arrow.
9 Remove the solder.
4
switch
(S501)
5 two screws
(1.7)
1 two claws
battery terminal (+)
5 screw (1.7)
5 screw (1.7)
ditch
3 Peel off the transparent plate
from adhesive sheet.
– Front top view –
5 two screws
(1.7)
6 Lift up the holder
(headphone) block.
8 holder
(headphone)
7 Remove the battery
terminal (+) in the
direction of an arrow.
– Front top view –
ire ettin
MAIN board