Table of Contents
Advertisement
Removing Collected Water
There are 2 ways to remove collected water:
1
Use the continuous drainage option from the bottom hole.
■ Drains as follows.
1.
During cooling or drying operations, condensed water will drain to the chassis and
be spattered as it strikes the motor. As the condenser is hot, most of this
condensation will evaporate and drain to the outdoors on its own. Very little
condensed water will accumulate inside the chassis, so you will not need to
discharge the water frequently.
Once the chassis is full of water, the unit will buzz 8 times and the "H8" code will
2.
display to remind you to discharge the water:
Move the unit to a suitable place for discharging water. Keep the unit horizontal
when moving; do not tilt.
Remove the rubber plug at the drainage port to discharge the water.
Put the rubber plug back into the drainage port after the water has drained out.
The H8 display will disappear. Once the compressor has been stopped for 3
minutes, the unit will resume operation.
drainage port
24
Advertisement
Table of Contents
