D-Link DIR-508L Faq page 13

Hide thumbs Also See for DIR-508L:

Table of Contents

secSon.

Step 5: Click Save to save the sebngs.

3. How do I reset my DIR-508L to factory default settings?

Example:

a. If you forget your router's password, you can perform a reset to return all settings to the

factory default.

Step 1: While the router is on, use the end of a paper clip to press the buUon inside the

pinhole on the side of the router, as highlighted by the red square below.

Step 2: Hold the buUon down for 10 seconds and then release.

Step 3: The unit will reboot automaScally. Once the WLAN light stops blinking, the unit has

been reset. Resebng the router does not reset the ﬁrmware to an earlier version, it only

changes all sebngs back to factory defaults.

Note: 1. The factory default username is Admin, and there is no password.

2. You will need to register the router with mydlink again aeer a factory reset.

Table of Contents