Preparation Steps - Honeywell CT60 Manual

Wts cloud, handheld

Hide thumbs Also See for CT60:

1 Introduction

This document outlines the tasks to be completed to prepare a CT60 handheld device

that will be used for a WTS project.

It mainly consists in installing a few pieces of software and applying a few settings. This

operation should take less than 15 minutes per device

2 Pre-requisite

1- Get a micro SD Card with mobile apps to be installed

The WTS and SOTI mobile apps to be installed on the CT60 device should be copied on a

micro SD card.

2- Be connected on Internet through a Wifi network

Connect the CT60 on a Wifi network enabling Internet access.

Please refer to Google Android help or CT60 help to connect to a Wifi network.

3 Preparation steps

Step 1 – Install Micro SD Card

Remove CT60 battery at the back of the device and place the micro SD card in the slot

Page 2

Table of Contents