Advertisement

SPAR-10-25
Instruction manual
DE – ACHTUNG: Die Verwendung des INNOTECH-Produkts ist erst zulässig, nachdem die
Gebrauchsanleitung in der jeweiligen Landessprache vollständig gelesen und verstanden wurde.
EN – ATTENTION: Use of the INNOTECH product is permitted only after the instruction
manual has been read and fully understood in the respective language.
IT – ATTENZIONE: L'utilizzo del prodotto INNOTECH è permesso solo previa lettura e
comprensione dell'intero manuale di istruzioni nella lingua del relativo paese di utilizzo.
FR – ATTENTION : L'utilisation du produit INNOTECH n'est autorisée qu'après avoir
entièrement lu et compris la notice d'utilisation dans la langue du pays concerné.
NL – ATTENTIE: Dit INNOTECH-product mag pas gebruikt worden nadat u de gebrui-
kershandleiding in de taal van het betreffende land gelezen en begrepen hebt.
SV – OBS: Denna INNOTECH-produkt får inte användas förrän bruksanvisningen på
respektive lands språk har lästs igenom och förståtts.
DK – GIV AGT: Du må først bruge et produkt fra Innotech, efter du har læst og forstået
brugsvejledningen i fuldt omfang i dit lands sprog.
ES – ATENCIÓN: Se autorizará el uso de los productos INNOTECH una vez que se hayan
leído y entendido las instrucciones de uso en el idioma del país.
PT – ATENÇÃO: O uso do produto INNOTECH apenas é permitido depois de ter lido e
compreendido na totalidade as instruções de uso na respetiva língua nacional.
PL – UWAGA: Produkty firmy INNOTECH mogą być używane dopiero po dokładnym
zapoznaniu się z całą instrukcją obsługi w ojczystym języku.
TR – DİKKAT: INNOTECH ürününün kullanımına ancak ilgili ülkenin dilinde sunulmuş
olan kullanım kılavuzunun tamamen okunmasından ve anlaşılmasından sonra izin verilir.
SL – POZOR: Uporaba izdelka INNOTECH je dovoljena šele po tem, ko ste navodila pre-
brali v celoti v ustreznem jeziku svoje dežele in jih tudi razumeli.
CZ – POZOR: Práce s výrobkem INNOTECH je povolena teprve po kompletním přečtení a
porozumění návodu k použití v jazyku daného státu.
SK – POZOR: Produkt INNOTECH môžete používať až po prečítaní a porozumení celého
návodu na použitie pre príslušnú krajinu.
HU – FIGYELEM: Az INNOTECH termékek használata csak azt követően engedélyezett,
hogy saját nyelvén elolvasta és megértette a teljes használati utasítást.
注意:只有在仔细阅读并完全理解了当地语言的使用说明后,才能使用 INNOTECH 公司的产品。
ZH –

Advertisement

Table of Contents
loading

Summary of Contents for Innotech SPAR-10-25

  • Page 1 SV – OBS: Denna INNOTECH-produkt får inte användas förrän bruksanvisningen på respektive lands språk har lästs igenom och förståtts. DK – GIV AGT: Du må først bruge et produkt fra Innotech, efter du har læst og forstået brugsvejledningen i fuldt omfang i dit lands sprog.
  • Page 2: Table Of Contents

    INSPECTION WARRANTY APPROVAL SIGNS & MARKINGS [10] DIMENSIONS [11] INSTALLATION INSTRUCTIONS [12] INSTALLATION SUBSTRATE [13] INSTALLATION TOOL [14] INSTALLATION [15] DISPOSAL [16] ACCEPTANCE LOG [17] SAFETY SYSTEM INSTRUCTIONS [18] TEST LOG [19] DEVELOPMENT & SALES SPAR-10-25 / 180223 / www.innotech.at...
  • Page 3: Description Of Symbols

    For a potentially DANGEROUS situation which results in serious physical injury or death. WARNING For a POTENTIALLY dangerous situation which could result in slight physical injuries and material damage. CAUTION Additional information/tip  ü correct wrong SPAR-10-25 / 180223 / www.innotech.at...
  • Page 4: Safety Instructions

    The restraint system may be installed only by specialised experts familiar with the roof safety system and in compliance with the current state of the art. When installing/using the INNOTECH "SPAR-10-25" anchorage device, comply with the respective accident prevention regulations (e.g. working on roofs).
  • Page 5 Follow the specific instructions for each element. Attachment to the INNOTECH "SPAR-10-25" is always made with one carabiner through the rotating anchorage eye, and this must be used with personal protective equipment in accordance with EN 361 (safety harness) and EN 363 (fall arrest system).
  • Page 6: Components/Material

    E) Anchorage eye Stainless steel, quality 1.4301 INTENDED INNOTECH "SPAR-10-25" was developed as an anchorage point for the personal safety of 3 people (including 1 person for the provision of first aid) and it is suitable for the following fall protection systems in accordance with EN 363:2008:...
  • Page 7: Inspection

    (written documentation). If necessary, replace the product. INSPECT EVERY YEAR Have INNOTECH "SPAR-10-25" inspected at least once each year by a specialist who is familiar with the restraint system. The user's safety depends on the effectiveness and reliability of the equipment.
  • Page 8: Warranty

    INNOTECH assumes neither responsibility nor warranty in the case of improper use. APPROVAL INNOTECH "SPAR-10-25" was tested and certified as an anchorage device as per EN 795:2012 TYPE A CEN/TS16415. The notified authority participating in the type test: DEKRA EXAM GmbH, Dinnendahlstr.
  • Page 9: Signs & Markings

    D) Maximum number of people who can be secured: 3 (including 1 person for provision of first-aid) E) Year of manufacture and manufacturer's serial number: JJJJ-..F) Number of the applicable standard: EN 795:2012 TYPE A Z-14.9-732 SPAR-10-25 / 180223 / www.innotech.at...
  • Page 10: Dimensions

    DIMENSIONS [mm] marking Beschriftung M 16 INSTALLATION INSTRUCTIONS Use INNOTECH "SPAR-10-25" only as a replacement anchorage eye on INNOTECH post structures (anchorage points), e.g.: on INNOTECH "STABIL/STA-10-300" INNOTECH "FALZ-15/45", ... Exception: INNOTECH "EAP-POINT-11/-12", "EAP-VARIO-15" Use the eyebolt as an anchorage...
  • Page 11: Installation Substrate

    INSTALLATION SUBSTRATE The basic prerequisite for correct technical installation is an INNOTECH anchorage point tested and fitted as per EN 795:1996 or EN 795:2012, and the use of the original fastener listed in this manual. DANGER TO LIFE from installation on an unsuitable substrate.
  • Page 12: Installation

    Install INNOTECH "SPAR-10-25" correctly as per instruction DANGER manual. Refer to the respective instruction manual for the edge spacings of the INNOTECH anchorage point from the end of the roof deck. ü DONE! SPAR-10-25 / 180223 / www.innotech.at...
  • Page 13: Disposal

    DISPOSAL Do NOT throw the restraint system into domestic waste. As per national requirements, gather together the used parts, and send them for environmentally friendly re-use. SPAR-10-25 / 180223 / www.innotech.at...
  • Page 14: Acceptance Log

    Specialist: Company address: FASTENER & PHOTO DOCUMENTATION PRODUCT: Item _________ Year of manufacture/Serial number: ___________ Type designation of anchorage point (e.g.: INNOTECH "STABIL/STA-10-300", INNOTECH "FALZ-15/45", ...) Photos: Date: Location: (storage location) The installation company which signs confirms the correct workmanship (edge spacings, inspection of the substrate, etc.) The customer accepts the contractor's services.
  • Page 15: Safety System Instructions

    If there is strain caused by fall, or if in doubt, the anchorage device must be taken out of service immediately and sent to the manufacturer, or to a specialised workshop for inspection and repair. The same applies if there is damage to the anchorage equipment. SPAR-10-25 / 180223 / www.innotech.at...
  • Page 16: Test Log

    TEST LOG TEST LOG NO. ____ (Part 1/2) ORDER NUMBER: PROJECT: PRODUCT: Item SPAR-10-25 Year of manufacture/Serial number: __________ (Type designation SINGLE ANCHORAGE POINT) ANNUAL SYSTEM INSPECTION CARRIED OUT ON: LATEST DATE FOR ANNUAL SYSTEM INSPECTION: CUSTOMER: Specialist: Company address:...
  • Page 17 Technical safety reliability is confirmed. Comments: _________________________________________________________ Name: _____________________________ ______________________________ Customer Inspection: Contractor (specialist who is familiar with the restraint system) ___________________________________________ _____________________________________________ Date, company stamp, signature Date, company stamp, signature SPAR-10-25 / 180223 / www.innotech.at...
  • Page 18: Development & Sales

    DEVELOPMENT & SALES INNOTECH Arbeitsschutz GmbH, Laizing 10, 4656 Kirchham/Austria. www.innotech.at SPAR-10-25 / 180223 / www.innotech.at...

Table of Contents