GE ASV06 User And Care & Installaion Manual page 14

PROBLEM
Answer Center@
GE
800.626.2000
consumer information service
14
QUESTIONS?
USE THIS PROBLEM SOLVER
Not plugged in. Plug may have been bumped loose by vacuum cleaner
or furniture.
*If plugged in, fuse could have blown or circuit brder may have tripped.
air flow.
Thermostat Control may not be set high enough. Tum knob to a higher
number. Highest setting should provide rn=imum coofing.
filter dirty,
Air
Cleaning s=tion.
*Room may have been very hot when air conditioner was f~st turned on.
Cold air maybe escaping through open furnace floor registers and
*Ventilation control may be set at OPEN position, allowing hot outside air to
enter the room.
Cooling coils have iced up. To melt ice, set the Seleetor Switch to HIGH FAN
and the Thermostat Control to a lower number.
Thermostat cfick, a metallic sound, may be heard when compressor cycles on
and off. This is normal.
Fans run continuously when Selector Switch is in COOL or FAN position.
This is normal.
This is normal.
Air conditioner must be instiled with the speeified tdt to the outside for
proper water disposd.
* ~s is normal for a short period in areas with litie humidity; nod for a
longer period in very humid areas. Moisture removed from indoor air drains
to rear of cabinet where it is picked up by a fan and thrown against the outdoor
condenser coil.
should be cleaned at least every 30 days. See the Care and