Cobra 602-2611 Instruction Manual

Items Supplied >
1 - Detachable (BA) Chrome or Black Rack with
Latches
2 - 3/8" I.D. Front Mounting Bushings
2 - 3/8" I.D. Rear Bushing Spacers
2 - 3/8" I.D. Rear Bushing Sleeves
2 - 3/8" I.D. Rear Bushings
4 - 3/8"-16 x 1-3/4" Button Head Bolts Zinc
Instruction Manual >
Read all instructions carefully before installing your new Cobra
1. Remove the front bolt from the right side fender rail and discard. NOTE: Remove one side only so the
fender does not fall resulting in possible scratches or damage to the fender or paint. See FIGURE 1.
2. Install the front mounting bushing into the front hole using the supplied 3/8"-16 x 1-3/4" long
buttonhead bolt and tighten bolt securely. See FIGURE 3.
3. Remove the right rear fender rail bolt and discard. See FIGURE 1.
4. Assemble the supplied plastic bushing over the sleeve as shown in FIGURE 2. Make sure the
chamfered inner edge goes towards the wide end of the sleeve.
5. Install the rear bushing assembly as oriented in FIGURE 3, using the supplied 3/8"-16 x 1-3/4" long
button head bolt and tighten bolt securely.
REMOVE STOCK
REAR BOLT
* Cobra recommends you always wear a helmet while riding. Please never operate your motorcycle while under
®
the influence of alcohol and/or drugs. Enjoy the new look of your motorcycle and please ride safely.
DOCUMENT NO. 0017 REV. B
01/20
23801 E. La Palma Ave., Yorba Linda, CA 92887 Ph. 714.692.8180 Fax. 714.692.5016
Application(s) >
HARLEY:
SOFTAIL:
ONLY ABOVE MODELS AS OF JANUARY 2020
(
602-2611 / 602-2611B
FIGURE 1
www.cobrausa-vtwin.com
FLSL 2018 - 2020
FXBB 2018 - 2020
Page 1 of 3
product!
®
REMOVE STOCK
FRONT BOLT
CONTINUED ON PAGE 2
)