Advertisement
Instruction Manual >
MAKE
SURE
LATCH PIN
IS FULLY
ENGAGED
UNDER
BUSHING
9. Pull backward on both detachable latch knobs and then push downward on the rack to allow the rack
to sit completely on the rear mounting bushings. Then release the detachable latch knob to fully
engage the latch pin underneath the mounting kit bushing. See FIGURE 5.
10. Always check to make sure both detachable latch pins are fully engaged on the bottom of the
mounting kit bushing. See FIGURE 5.
11. Before each ride, check to make sure the detachable latches are fully engaged underneath the
mounting bushings.
12. Check the tightness of all the screws after the first ride, after the first 500 miles, and at every engine
service thereafter.
To clean your black accessory use a liquid based soap detergent, such as dishwashing soap applied with a soft cloth and
rinse with clean water. Note: Avoid abrasive cleaning methods such as granular or dry cleansers, simple green, Scotch-
Brite or steel wool pads. Abrasives may breach the coating and shorten life.
DOCUMENT NO. 0018
REV. A
01/20
23801 E. La Palma Ave., Yorba Linda, CA 92887 Ph. 714.692.8180 Fax. 714.692.5016
602-2611 / 602-2611B
FIGURE 5
www.cobrausa-vtwin.com
Page 3 of 3
Advertisement
