Kohler KARAT K-17399 Installation Manual

INSTALLATION GUIDE
Seat
Install the Toilet Seat
Assemble seat and seat cover with plastic bushing for hinges. Insert plastic
bushing for hinges into the that are located on the back of seat and seat cover,
use the inner-side holes.
Insert rubber sleeves into the toilet seat mounting holes.
Insert hinge cap into the hinge.
Assemble toilet seat with the toilet by inserting hinges into rubber sleeves
and align the position properly.
CAUTION: Risk of product damage. Do not overtighten the nuts.
Insert rubber washer, washer and tighten the wing nuts. Center the seat
as needed.
Open up and close down the toilet seat to ensure the proper installation.
Care and Cleaning
Clean the outside surface of your toilet seat with mild soap, such as liquid
dish soap and warm water. Wipe the entire surface completely dry with
a clean soft cloth. Do not use any abrasive cleaners, as they will scratch and
dull the surface. Avoid any detergents, disinfectants, or cleaning products
in aerosol cans. Avoid contact with abrasive chemicals and cosmetics, such as
fingernail polish and aftershave, as they may damage the finish of your
toilet seat.
X product numbers are for Thailand (i.e. K-12345X)
Cover
TOILET SEAT
K-17900, K-18119, K-18121
Toilet Seat
Mounting Holes
K-17399, K-17400,
Plastic
Bushing
Hinge
Rubber Sleeve
Rubber Washer
Washer
Nut
1049495-X2-B