Checking Your Vent - Whirlpool TEDS680E Cycle Descriptions

Whirlpool washing machine user & care guide tedx640e teds680e
Table of Contents

Advertisement

C
Y
HECKING
Your dryer must be properly installed and vented to achieve maximum drying efficiency and
shorten drying times. Use the minimum recommended installation clearances (found in your
Installation Instructions) to avoid blocking the flow of combustion and ventilation air. Install
your dryer in a well-ventilated room where the temperature is always above 45ºF. Also make
sure that your dryer is leveled. Refer to your installation Instructions for more
information.
wWARNING
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions can
result in death or fire.
If the dryer is not properly installed and vented, it will
not be covered under the warranty.
NOTE: Service calls caused by improper venting will
be paid for by the customer, whether it was a paid
installation or self-installed. For paid installation, call
the company that installed the vent for adjustment.
1.
Do not use plastic vent or flexible metal foil vent.
4 "
4 in
length requirements of vent.
6
V
OUR
ENT
Use 4-inch heavy metal
or flexible metal vent.
Do not kink or crush
flexible metal vent. It
must be completely
extended to allow
adequate exhaust air to
flow. Check vent after
installation. Refer to
your Installation
Instructions for proper
2.
Use a 4-inch exhaust hood. Smaller hoods
4"
4 in
4"
4 in
3.
The exhaust vent can be routed up, down, left,
increase drying times.
right, or straight out the
back of the dryer. Space
requirements are listed
in your Installation
Instructions.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tedx640e

Table of Contents