Table of Contents
Advertisement
Other operating instructions
For a rinse and spin
You may need an extra rinse and
spin for heavily
soiled loads which
need more detergent.
(Extra detergent
can require
an extra rinse.]
1. Push Control Knob in.
2. Turn clockwise
to any
l
on the dial.
See above
drawing.
3. Pull Control Knob out. The washer
will fill to selected
level; agitate
2
minutes; drain and spin.
For a drain and spin
Your washer can be set to drain and
spin out water.
1. Push Control
Knob in.
2. Turn clockwise
to the bar just before
the OFF area in any cycle.
See
above
drawing.
3. Pull Control Knob out. The washer
will drain and spin.
For agitation
and spin speeds
in each
cycle,
see pages
6-9.
For a soak
For best results, use warm water
for soaking
or pre-washing
stained
laundry
Hot water
can set stains.
1. Use recommended
amount
of
detergent
or pre-soa k product.
2. Push Control Knob in.
3. Turn clockwise
to point to the
number
in the SOAK Cycle.
4. Pull Control Knob out. The
washer will start.
5. When the cycle
is over, add
detergent
for the next selected
wash cycle. The SOAK Cycle
should
always
be followed
by
a Wash Cycle.
Important:
See additional
care
information
in your "Laundry
Guide!'
'To start soak with agitation,
the Control Knob
must point to the number
in the SOAK Cycle.
10
Advertisement
Table of Contents
