Parts and features Copy your Model and Serial Numbers When you need service or call with a question, have this information ready: 1. Complete Model Serial bers(from plate underthe lid nearthe hinge). 2. Purchase date from sales slip- Copy this information in these spaces.
WHAT HAPPENS IN EACH CYCLE CARING FOR YOUR WASHER IF YOU NEED SERVICE OR ASSISTANCE 1. Before Calling Assistance 2. If You Need Assistance 3. If You Need Service 4. If You Have a Problem G1984 Whirlpool Corporation -SAVE THESE INSTRUCTIONS...
Starting your washer Before sfarfina vour washer: Select a 1. LOAD SIZE Turn the knob to point at a setting that describes the size of load you want to wash. Set the knob anywhere on or between EX SMALL (a few items] and LARGE (a full load).
Page 5
3. Start the washer Push in the Control Knob and turn it to the right. It must be pushed in and turned only clockwise. Start the washer by pulling the Control Knob. The washer will fill to the level you set with wash water of the selected temperature.
instructions Other operating For a rinse and spin You may need an extra rinse and spin for heavily soiled loads which need more detergent. [Extra de- tergent can require an extra rinse.) Push Control Knob in. Turn clockwise to any on the dial.
Liquid bleach dispenser Always measure bleach. Do not guess. Follow directions on the bottle for the amount to use. Never more than 1 cup (250 ml) for a full load. Use less with lower water level settings. Use a cup with a pouring spout to avoid spilling.
What happens in each cycle Each cycle has different agitation kinds of fabrics. Numbers on the dial in each agitation time. When the Cycle Control Knob is set to a number fills before agitation and timing REGULAR HEAVY Cycle High agitation spin speeds heavy water...
Page 9
clockwise until it points to OFF and the cycle NOTE: You may hear the sound of water spraying cycles. In some cycles, cold water is sprayed the rinsing. Special care is needed See your “laundry Guide” ends. during the spin parts of some on the spinning load to help with when soaking...
Caring for your washer WHEN NOT WASHING, keep both water faucets turned off. This takes the pressure off the water inlet valve and hoses. REMOVE SHARP OBJECTS such as pins, buckles, etc., from clothes before washing. Close metal zippers. AFTER WASHING, use a soft dry cloth to wipe the outside and inside dry.