Whirlpool LA3800XP Use & Care Manual page 5

HOT WATER can be selected only
in the REGULAR HEAVY Cycle. Turn the
Control Knob tol2or 14 minutes in the
REGULAR HEAVY Cycle.
All rinses use cold water. This saves
energy and helps prevent wrinkles
from seftlng into fabrics.
To select a
3.
WATER LEVEL
I
HIGH WATER LEVEL. The washer will
LOWER WATER LEVELS. Setting the
automatically fill to its highest level,
washer to fill with less water also sets it
(about 20.5 gals.177.6 L), when the
for a shorter wash time.
Control Knob points to a FILL area.
1. Push the Control Knob in and turn it
v clockwise to a FILL area in the cycle
Be careful to use enough water
you want.
for the load. Too big a load or
2. Pull the Control Knob out; the washer
too little water can cause poor
will start to fill.
cleaning and wear or tear load
3. When the washer reaches the de-
items.
sired water level, push in the Control
For best results, the load should
Knob and slowly turn it past the FILL
move freely in the water. Watch
area. Pull out the Control Knob to
for rollover. An item (like a sock]
start the washer.
should sink and come up again
For all rinses, the washer fills to Its
later.
highest level with cold water.
To select a
2.
WASH WATER TEMPERATURE
WARM WATER can be selected by
turning the Control Knob to B or10 min-
utes in the REGULAR HEAVY Cycle.
l
A warm wash is preset in the SHORT
Cycle. Just turn the Control Knob to
the 6 or 8 minute setting in that
CyCle.