No-Beep Symptoms; Lcd-Related Symptoms - Lenovo ThinkPad 11E Hardware Maintenance Manual

Table 3. Beep symptoms (continued)
Symptom or error
Four cycles of four short beeps
Five short beeps
Five short beeps, pause, five more short beeps, and
pause

No-beep symptoms

Table 4. No-beep symptoms
Symptom or error
No beep, system-status indicator on, LCD blank, and no
POST.
No beep, system-status indicator on, and LCD blank
during POST.
The power-on password prompt appears.
The hard-disk password prompt appears.

LCD-related symptoms

Important: The TFT LCD for the notebook computer contains many thin-film transistors (TFTs). The
presence of a small number of dots that are missing, discolored, or always lighted is characteristic of TFT
LCD technology, but excessive pixel problems can cause viewing concerns.If the LCD you are servicing has
two or less visible defective pixels, it should not be considered faulty. However, if the LCD has three or more
visible defective pixels, it will be deemed as defective by Lenovo and it should be replaced.
Notes:
• This policy applies to all ThinkPad notebooks purchased on 1 January, 2008 or later.
• Lenovo will not provide replacement if the LCD is within specification as we cannot guarantee that any
replacement LCD will have zero pixel defects.
• One pixel consists of R, G, B sub-pixels.
Table 5. LCD-related symptoms
Symptom or error
No beep, system-status indicator on, and a blank LCD
during POST.
• LCD backlight not working.
• LCD too dark.
• LCD brightness cannot be adjusted.
• LCD contrast cannot be adjusted.
40
11e 5th Gen and Yoga 11e 5th Gen Hardware Maintenance Manual
FRU or action, in sequence
System board
System board
TCG-compliant functionality-related problem
FRU or action, in sequence
1. Ensure that every connector is connected tightly
and correctly.
2. System board
System board
A power-on password or a supervisor password is
set. Type the password and press Enter.
A hard-disk password is set. Type the password and
press Enter.
FRU or action, in sequence
System board
1. Reseat the LCD connectors.
2. LCD assembly
3. System board