Whirlpool GR556LRKB0 Installation Instructions Manual page 6

Four-wire electrical
connection:
Figure 1
line 1
green
ground
wire
Figure 2
Use this method for new installations,
mobile homes, recreational vehicles,
and whenever four-wire installation is
required.
10. Remove the ground-link screw from
the range frame. Save the ground-
link screw and cup washer. Bend up
the ground link so that it does not
contact the range. See Figures 1
and 2.
11. Connect the green ground wire
from power supply cable to the
range using the ground screw and
cup washer. The ground wire must
be attached first and must not
contact any other terminal. See
Figure 2.
12. Loosen (do not remove) the 3
slotted set screws. Insert the neutral
(white) wire into the hole at the
bottom of the center position
terminal lug (attached to center
terminal screw black terminal
block). See Figure 2.
13. Connect the other two wires (lines
1 and 2) to the outer aluminum
terminal lugs.
14. Securely tighten the set screws. For
8 gauge copper wire, tighten to
25 in/lbs of torque, and for 6 gauge
aluminum wire, tighten to 35 in/lbs
of torque to make a proper
electrical connection. See Figure 2.
15. Tighten the locking ring and
clamping screws of the conduit
connector.
16. Replace the terminal block cover.
6
Three-wire electrical
connection:
ground link
ground
line 1
screw
Use this method only if local codes
slotted
permit connecting ground conductor to
set screw
neutral supply wire.
10. Loosen (do not remove) the 3
line 2
slotted set screws. Insert the neutral
(white) wire into the hole at the
neutral
bottom of the center position
(center
terminal lug (attached to center
wire)
terminal screw of terminal block).
See Figure 3.
11. Connect the other two wires (lines 1
and 2) to the outer aluminum
terminal lugs.
12. Securely tighten the set screws. For
8 gauge copper wire, tighten to
25 in/lbs of torque, and for 6 gauge
aluminum wire, tighten to 35 in/lbs
of torque to make a proper
electrical connection. See Figure 3.
13. Tighten the locking ring and
clamping screws of the conduit
connector.
14. Replace the terminal block cover.
slotted
set screw
line 2
neutral
(center
wire)
Figure 3
Now start...
With range in kitchen.
1.
Remove shipping materials, tape
and protective film from range. Keep
cardboard bottom and shipping base
under range. Remove oven racks and
parts package from inside oven.
2.
Take 4 cardboard corners from the
carton. Stack one cardboard corner on
top of another. Repeat with the other two
corners. Place corners lengthwise on the
floor in back of range so corners will
support outer side edges of range as
shown.
spacers
WARNING
Excessive Weight Hazard
Use two or more people to move and
install range.
Failure to do so can result in back or
other injury.
3.
Firmly grasp the range and gently
lay it on its back on the cardboard
corners.
4.
Pull cardboard bottom and
shipping base firmly to remove.
5.
Use an adjustable wrench to
loosen the leveling legs 1-1/2 turns.
cardboard
corners