Table of Contents
Advertisement
Positioning and connecting
en
The following are available from
Tip:
specialist dealers/customer service:
Extension for Aqua-Stop or cold
■
water supply hose (approx. 2.50 m).
Order no. WZ10130
A longer supply hose (approx. 2.20
■
m) for standard model.
Water connection
:
Warning
Risk of electric shock!
Danger of death if live parts are coming
into contact with water.
Do not immerse Aqua-Stop safety
device in water (contains an electric
valve).
Caution!
Water damage
The connection points for the water
supply hose and water drain hose are
under high water pressure. To prevent
leaks and water damage, you must
follow the instructions in this section.
Notes
In addition to the safety information
■
listed here, the local water and
electricity supplier may have special
requirements.
Only operate the washing machine
■
using cold mains water.
Do not connect the washing
■
machine to the mixer tap of an
unpressurised hot-water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
If in doubt, have the appliance
■
connected by a technician.
24
Water inlet
Notes
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw connections
■
by hand. If the screw connections
are tightened too much with a tool
(pliers), the thread may become
damaged.
Optimum water pressure in the mains:
100-1000 kPa (1-10 bar)
When the tap is open, the water flow
■
is at least 8 l/min.
If the water pressure is higher than
■
this, a pressure-reducing valve must
be installed.
Connection
Connect the water supply hose to the
water tap (¾" = 26.4 mm) and to the
appliance (not necessary for Aqua-Stop
models):
Aquastop
■
Standard
■
Carefully turn on the tap and check that
the connection points are not leaking.
The screw connection is under
Note:
water pipe pressure.
Advertisement
Table of Contents
