Whirlpool ET16TK Use & Care Manual page 6

Changing the light bulb...
Unplug the retrlgerator tlrst.
1. Reach behind control console to find bulb
2. Remove bulb.
3. Replace with a 40-w& appliance bulb.
Moving
the meat pan and cover...
The meat pan and cover can be removed for
Removing:
cleaning and moved to another shelf, If desired.
1. Slide the pan out to stop.
Remove the meat pan first.
2. Lift the front of meat pan.
3. Slide pan the rest of the way out.
4. Tilt cover up at front.
5. Pull forward and out.
Replacing:
1. Fit notches underneath cover over rear and center
cross bars on shelf.
2.
Lower cover in place.
3. Replace meat pan in reverse order.
Adjusting the refrigerator shelves...
1 Ftrst, remove food from shelf.
2. Slide shelf straight out to stop.
3. Lift front.
4.
Slide the rest of the way out
Replacing Shelf:
Guide Star
Shelf
Stop
1. Fit back of shelf on top of guides with wire stops
on the bottom of guides.
2. Lift front, slide shelf In until it clears gurde stops
,. 8. . . ..~ .-
Shelf Guide
Removing crisp&s aid crisper cover.. .
Removing the Crispers:
Lift the Front, Then the Back.
1. Slide crisper straight out to stop, lift front, then slide
the rest of the way out.
2. Replace in the reverse order
Removing Cover:
1 Lift front and remove the cover support
2. Lift out cover by pulling up and out.
Replacing Cover:
1. Fit back of cover into notch supports on walls of
refrigerator, then lower front into place.
2. Replace cover support with the long tab towards
the front.
Note:
If support needs adjustment, turn
base right to lower, or left to raise.
Pull out to stop.
ront and Pull Again.
To remove shelf:
I, Lift front slightly.
2. Lift back off supports.
3. Replace in reverse order.
To adjust shelf:
1. Remove shelf.
2. Remove supports by sliding upwards.
3. Replace supports on desired level.
4. Replace shelf.
Shelf Support
6