Download Print this page

Installation - Sony RMM-131 Installation Instructions Manual

Rack mount kit

Advertisement

取り付けかた

Installation

/Installation/Installation/Installation
取り付けかた
取り付けは必ず2人以上で行ってく ださい。 取り付ける機器をレー
ルに差し込むと きに機器をしっかり支えないと、 けがや事故の原因
となり ます。 特にス ト ッパーと レールの間に指を挟まないよう にご注
意く ださい。
Caution
The equipment should be installed into the rack mount
by two or more persons. The equipment must be
firmly supported when it is placed onto the rails. If not,
an injury or accident could result. Take care not to
catch your fingers between a stopper and a rail.
1
2
ストッパー
Stopper
Butée
Anschlag
外側レール
Outer rail
Rail externe
Außenschiene
A
6
/Installation/Installation/
底面
Bottom side
Dessous
Unterseite
内側レール
Inner rail
Rail interne
Innenschiene
Attention
L'appareil doit être installé dans le kit de montage par
deux personnes au moins. Il doit être fermement
soutenu à son positionnement sur les rails. Sinon, des
blessures ou un accident sont possibles. Prendre garde
de ne pas se coincer les doigts entre une butée et un
rail.
Achtung
Zur Installation sind mindestens zwei Personen
erforderlich. Das Gerät muß sicher auf den Schienen
sitzen, um die Gefahr von Verletzungen und
Sachschäden zu vermeiden. Achten Sie darauf, nicht
die Finger zwischen Anschlag und Schiene
einzuklemmen.
1
機器に内側レールを取り付ける
1 機器の底面の足を外す。
外した足とネジは、 後日使用する場合のために保管してく ださい。
2 レール A のス ト ッパーを押しながら、内側レールを引き抜く 。
3 機器側面中央のネジを外し、 外したネジで内側レールを機器
に取り付ける。
内側レールの先端から、 機器の前面までが約57mmになるよ
う に取り付けます。
4 機器前側面のネジを外し、 取っ手Bに付いているネジで機器
に取っ手を取り付ける。
1 Attaching the inner rails to the
equipment
1 Remove the feet and screws from the bottom of the
equipment.
Retain them for possible future use.
2 While pressing down the stopper, pull out the inner rail from
the rail
.
A
3 Remove the center screws from both sides of the equipment.
Then use the screws to attach the inner rails to the equipment.
Attach the inner rails so that the distance between the tip of
each rail and the front panel of the equipment is about 57 mm
(2
1
/
inches).
4
4 Remove the screws on the front part of both sides of the
equipment and attach the handles B to the equipment with the
screws on the handles.

Advertisement

loading