Whirlpool EL13PC Use & Care Manual page 4

Install properly.. .
71 -
11 I I
_iD!
r I
1. Allow 3 inches (7.5 cm) between overhead cab-
inets and the refrigerator top.
2. Allow at least an inch (2.5cm) between the refrig-
erator condenser and the wall.
3. Allow '/z inch (1.25 cm) on each side of the re-
frigerator for ease of installation.
4. If the refrigerator is to be against a wall, you might
want to leave enough space so the door can be
opened wider.
Level refrigerator.. .
Raise
Lower
1. Keep the 4 bolts that held refrigerator in shipplng
crate. They are the levelling legs.
2. Screw these bolts all the way into bolt holes at the
bottom corners of refrigerator.
3. Adjust each leg until the refrigerator won't rock.
Slide refrigerator into place
4 Adjust front legs to level the refrigerator.
~ To raise corners, turn legs clockwise.
-To lower corners, turn legs counterclockwlse.
5. Check with level.
Remove sales labels..
l
Remove the Consumer Buy Guide label and other
InsIde labels before using the refrigerator Any glue
left can be taken off with rubbing alcohol.
NOTE: DO NOT REMOVE ANY PERMANENT IN-
STRUCTION LABELS INSIDE YOUR REFRIGERATOR.
Do not remove the Tech Sheet fastened under
the refrigerator at the front.
Clean it.. .
Clean your refrigerator before plugging It in or using
it See cleaning InstructIons on page 7
Plug it in...
3.prong
grounding type
wall receptacle
Refrigerator
Power Cord
RECOMMENDED GROUNDING METHOD
A 115 Volt, 60 Hz, AC only, 15 or 20 ampere fused
grounded electrical supply is required. It is recom-
mended that a separate circuit serving only this
appliance be provided
Do not use an extension cord. Use a recepta-
cle which cannot be turned off with a switch or
pull chain. See individual electrical requirements
and grounding instruction sheet in your literature
package
Turn it on...
r
l
Move rup switch to RUN
NOTE; The refrigerator motor will not operate un-
til the run switch is on RUN.
4