Download Print this page
Varioprop Uno S2R Instruction Manual

Varioprop Uno S2R Instruction Manual

2.4 ghz digital advanced fhss radio control system

Advertisement

Quick Links

ADVANCED FHSS RADIO
CONTROL SYSTEM
INSTRUCTION MANUAL

Advertisement

loading

Summary of Contents for Varioprop Uno S2R

  • Page 1 ADVANCED FHSS RADIO CONTROL SYSTEM INSTRUCTION MANUAL...
  • Page 2: Specifications

    Age Recommendation: Not for Children under 14 years. This is not a toy. SPECIFICATIONS • 2CH Transmitter with 2-channel S2R receiver. • The device has an integrated 2.4GHz antenna. • 7: 3 and 5: 5 Throttle regulator, reverse switches for throttle and steering.
  • Page 3 NOMENCLATURE Throttle Trim Adjusts the throttle in small increments so the model will not move at neutral. Steering Trim Antenna (Built-in) Adjusts the steering in small increments so the model will run straight. 5:5 / 7:3 ThrottleSwitch Adjust the proportion of throttle signal ON/OFF Switch Steering Dual Rate (D/R)
  • Page 4: Transmitter Functions

    TRANSMITTER FUNCTIONS ON/OFF SWITCH LED Status SOLID RED = OK FLASHING RED = Low Voltage (Replace batteries) Slide UP to turn ON the transmitter 7:3 / 5:5 PROPORTIONNAL THOTTLE SWITCH Slide DOWN for 5:5 Slide UP for 7:3 Adjust the proportion of throttle signal on either side of the centre trigger position. Use the proportion of Forward/Reverse you prefer.
  • Page 5 TRANSMITTER FUNCTIONS STEERING TRIM THROTTLE TRIM STERRING TRIM :The trim is used to adjust the steering THROTTLE TRIM :The trim is used to adjust the setting setting so that the car moves in a straight line without of the neutral position of the throttle without using the using the steering wheel to compensate.
  • Page 6: Failsafe Setting

    Button The S2R comes with failsafe set to neutral position on steering and throttle channel. In the event of loss of signal the motor will stop and the vehicle will drift. If the signal is regained normal function will return.
  • Page 7 CHANGING THE TRAVEL ADJUST SETTINGS (EPA) The EPA supports precise and individual endpoint adjustment in each direction for the steering and throttle channels. 1. Hold the throttle trigger in the full brake position while powering on the transmitter 2. The red LED flashes rapidly, indicating the programming mode is active. 3.
  • Page 8 CAUTION The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
  • Page 10 www.varioproprc.eu...