Using The Automatic Ice Maker - Whirlpool ED22DF Use And Care Manual

The water dispenser
Chilled water comes from a tank behind the
meat drawer. It holds approximately 1%
quarts (1.5 L). When the refrigerator is first
hooked up, press the water dispenser bar
with a glass or jar until you draw and discard
2 or 3 quarts (1.9 to 2.8 L). The water you
draw and discard rinses the tank and pipes.
Allow several hours to chill a new tankful.
NOTE: The small tray beneath the dispenser
is designed to evaporate small spills. There is
no drain in this tray. Do not pour water into it.
To dispense water:
1. Press a sturdy glass against the water
dispenser bar.
2. Remove the glass to stop dispensing.
NOTE: Dispense enough water every week to
maintain a fresh supply.
0
The dispenser light
To turn on night light, slide dispenser LIGHT
switch to the left. See page 19 for directions for
changing the dispenser light bulb.
WATER LIGHT
Using the automatic ice maker
Here are a few things you will want to know
about your automatic ice maker:
l
The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically.
UP to shut off the ice maker.
UP to
stop ice
NOTE: Do not turn ice maker on until it is
connected to the water supply. Instructions
for ice maker water supply hook up are
t
maker.
DOWN to
I
start ice
maker.
attached to the back of the refrigerator
cabinet.
l
It is normal for ice crescents to be attached
by a corner. They break apart easily.
l
The ice maker will not operate until the
freezer is cold enough to make ice. This can
take overnight.
l
If ice is not being made fast enough and
more ice is needed, turn the Refrigerator
Control toward a higher number. Wait a day
and, if necessary, turn the Freezer Control
toward C.
15