Table of Contents
Advertisement
Before Using Your
Refrigerator
In This
Section
Page
Page
Cleaning
it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Installing
it properly
. . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Plugging
it in . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Leveling
it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
It is important to prepare your refrigerator for use. This section will tell you how to clean it,
connect it to a power source, install it and level it.
Cleaning
it
Removing
packaging
materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining
glue:
l
Rub briskly with thumb to make a ball, then
remove.
OR
l
Soak area with liquid hand-dishwashing
detergent before removing glue as de-
scribed above. Do not use chart instru-
ments, rubbing alcohol, flammable fluids or
abrasive cleaners. These can damage the
material. See "Important Safety Instruc-
tions" on page 3.
Plugging
it in
Recommended
Grounding
Method
A 220 or 240 Volt, 50 Hz., AC only 15 or
20 ampere fused and properly grounded
electrical supply is required. It is recom-
mended that a separate circuit serving only
this appliance be provided. Use a receptacle
which cannot be turned off with a switch or
pull chain. Do not use an extension cord.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning
it before
use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions
on
pages 14 and 15.
5
Advertisement
Table of Contents
