Aquapure ei series
chlorine generating device
dual voltage 240v/120v (36 pages)
Summary of Contents for Jandy Laminar Jet
Page 1
Installation and Operating Data Installation and Operation Manual Jandy Laminar Jet WARNING FOR YOUR SAFETY - This product must be installed and serviced by a pro fes sion al pool/spa service technician. The procedures in this manual must be followed ex act ly. Failure to follow warning notices and instructions may result in property damage, serious injury, or death.
Preparing the Laminar Jet with LED Winterization ..........14 Light for Installation ......... 9 Installing the Laminar Jet with LED Light 9 Section 10. Parts List and Exploded View ... 14 Wiring Options for Controlling Laminar Jet 10.1 Parts List ..........14 with LED Lights ........
Read and follow the specifi c instructions below. WARNING Before installing this Laminar Jet with LED light, read and follow all warning notices and instructions accompanying this product. Failure to follow safety warnings and instructions can result in severe injury, death, or property damage.
Section 2. General Installation Critical Placement Dimensions Requirements The laminar jet can project a maximum of 7 feet up and 8 feet out into the water. Therefore, ensure the installation is This document gives instructions for installing the no more than 6 feet from the inside edge of the pool.
Section 3. Installing the Deck Canister 13.75 in. 12 in. NOTE Prior to installing the Jandy laminar jet deck canister, locate the jet opening (slot) in the 2.50 in. deck canister cover. Make sure that this opening is pointing towards the desired target location in the pool.
Out-of-Deck/Planter Box Installation Place the adjustable deck lid collar back on the canister. CAUTION Do not install the Jandy laminar jet deck canister in Pressure Test Water Lines an area prone to run-off or fl ooding or on a fl ammable surface.
4.3.2 Wiring to a Time Clock The laminar jet with LED lights can be wired into a basic time clock to automatically turn on the laminar jet with LED lights at a predesignated time. Refer to Figure 8 to connect the laminar jet with LED lights into the time clock.
Flush water lines to clear debris. Lines must be Tools Utility knife or hot knife; Heat gun or clear of debris before attaching the laminar jet propane torch. assembly. Cable Each jet requires 100 to 150 strands of fiber optic cable.
Laminar Jet 1" Stake Up Feature Figure 10. Laminar Jet Light and Flow Adjustment The laminar jet is installed on two (2) pivots. Section 7. Operating the Laminar Jet Loosen the locking screws to adjust the jet angle. with LED Light Refer to Figure 11.
This water stream NOTE To synchronize colors on multiple Jandy disturbs the surface of the laminar jet flow causing WaterColors light systems and Jandy Laminar an increase in the light intensity. Jets with LED Lights wired to separate...
& Unions clean up, reinstall the unions. Lid and Collar, Pebble, JLPBL Winterization Laminar Jet The laminar jet can be winterized in regions that require Lid and Collar, Pewter, JLPWTR winterization. Laminar Jet Remove the deck canister lid assembly and...
Page 16
If the dealer is not available, you can locate a service center in your area by visiting www.jandy.com or by calling our technical support department at 1.800.822.7933 in the United States or 1.888.647.4004 in Canada. All returned parts must have a Returned Material Authorization number to be evaluated under the terms of this warranty.