Table of Contents
Advertisement
Troubleshooting...
Troubleshooting...
The On indicator
lamp does not light
up.
The dryer does not
start.
The humidity in
the room has
increased
significantly.
The door opens by
itself.
Drying is not
satisfactory or the
drying time is too
long.
Cause
The dryer is not plugged
in.
No drying programme
has been set.
The circuit breaker has
tripped.
Start button has not
been pressed.
No drying programme
has been set.
The door is not shut.
The ambient tempera-
ture is below 5 °C.
The room is not
sufficiently ventilated.
The locking pin is not
engaged.
The filter is blocked.
Solution
Plug in the dryer.
Select the programme
you require using the
programme selector.
Reset/replace the fuse.
Press the button.
Select the programme
you require using the
programme selector.
Close the door.
Warm up the room.
Ensure sufficient
ventilation.
Push the door closed
until you hear the locking
pin click into place.
Clean the filter
(page 18).
19
Advertisement
Table of Contents
