Fisher & Paykel DCS TDS1-20 Quick Start Manual

QUICK START GUIDE
Outdoor Kitchen Storage solutions
US CA NZ AU
Keep this document handy for easy reference.
Before using your product, make sure you read the full 'Quick Start guide', with special attention to the 'Safety and warnings' section.
For contact information or if you require service, assistance or replacement parts, see the end of this document or your 'Service & warranty'
booklet.
SAFETY AND WARNINGS
WARNING!
Cut hazard
Take care - panel edges are sharp.
Failure to use caution could result in injury or cuts.
WARNING!
WARNING
Crush hazard
Closing drawers may cause injury to your hands or
fingers.
Always close or open drawers using their handles.
Be sure to keep hands away from drawer edges when
opening or closing drawers.
Failure to use caution could result in injury or cuts.
ing drawers may cause injury to
r hands or fingers.
IMPORTANT SAFETY INSTRUCTIONS!
ays close or open drawers using
r handles.
ure to keep hands away from
Do not allow children or pets to play in or around your outdoor
wer edges when opening or
accessories. Children could be seriously injured if they climb onto or into
ing drawers.
these products.
DANGER: Risk of child entrapment. Before you throw away your old
pantry:
- take off the doors
- leave the shelves and drawers in place so that children may not easily
climb inside.
MODEL OVERVIEW
DRAWERS WASTE BASKET
TDS1-20
TDT1-20
TDD1-20
Children, or persons with a disability which limits their ability to
use the appliance, should have a responsible person to instruct
them in its use. The instructor should be satisfied that they can use
the appliance without danger to themselves or their surroundings.
To avoid personal injury or damage to the products, do not
overload the drawers or shelves. The maximum allowable weight
for a drawer is 75 lbs / 35 kg.
Your pantry and drawer units are not refrigerated. Do not store
perishable foods in them.
Ensure your beverage chiller has been correctly installed and
connected to a drainage system.
Do not store or use gasoline or other flammable vapors and liquids
inside or in the vicinity of these or any other appliances.
An LP cylinder not connected for use shall not be stored inside or in
the vicinity of these products.
After having unpacked the appliance, check to ensure that it is not
damaged.
Packing elements (eg plastic bags, polystyrene foam, nails, packing
straps, etc.) should not be left around within easy reach of children, as
these may cause serious injuries.
Follow the installation instructions. The manufacturer is not
responsible for any damage or defects arising from improper
installation.
Some products are supplied with protective film on steel and alumini-
um parts. This film must be removed before using the appliance.
Do not modify this appliance.
PANTRY
DP1-42
TB1-20
PANTRY ARRANGEMENT (DP42 ONLY)
Important!
Letting the pantry door open more than 105 degrees
could result in marking of the outer surface finish
Please exercise caution when opening the door and
make sure that is is not opened more than 105
degrees.
Shelves
There is a choice of 3 positions for the two supplied shelves.
Drawers
The drawer inserts are removable for ease of
cleaning.
To remove:
Open the drawer fully and carefully lift out the insert.
You may also remove the entire drawer if required.
See 'Removing and replacing drawers'
WASTE BASKET (TB1-20 ONLY)
Important!
Do not use force to compact down trash as this may
damage the drawer glides.
The maximum total weight the waste baskets can hold
is 35 lbs / 16 kg each.
To avoid personal injury, caution should be used when lifting
full trash bins.
The drawer is soft closing, which requires less force to close.
BEVERAGE CHILLER (BC25 ONLY)
The condiment tray sits in the chiller as shown.
The four individual containers and lids may be
removed for cleaning / filling.
BEVERAGE CHILLER Beverage chiller lid
Ensure the lid sits level and secure on top of the chiller.
The side of the lid with the shorter lip fits on the front
of the beverage chiller. This allows the lid to sit flat if
the bottle holder* is installed.
BC25
Drainage
We recommend plumbing your Beverage Chiller into
a permanent drainage system. The connection to
the drainage system must be made by a certified
plumber and compliant with local and national code
BOTTLE HOLDER
requirements.
New Zealand & Australia only:
Use the supplied drain adapter to plumb the chiller.
BC-BOTTLEAC-25
*Bottle holder (optional)
The bottle holder is permanently fitted to the front of
your beverage chiller. It comes with a removable drip
tray for ease of cleaning.
*purchased separately. Contact Customer Care or your
Authorised DCS dealer; part no 71036.
Condiment Trays
BEVERAGE CHILLER
BOTTLE HOLDER