Advertisement
Adjusting
the oven temperature
control
Oven temperature
controls will gradually
shift after years of use. So, even though
your new oven is properly adjusted to
provide accurate temperatures,
it may cook
faster or slower than your old oven.
If, after using the oven for a period of time,
you are not satisfied with the temperature
settings, you can adjust them by following
these steps:
1.
2.
3.
4.
5.
Make sure the Oven Temperature
Control Knob is turned to the off position.
Pull knob straight off and flip it over.
Loosen the locking screws inside the
control knob. Note the position
of the
notches.
To lower the temperature,
hold knob
handle firmly and move the tooth a notch
clockwise.
Each notch equals about
20°F (11%).
To raise the temperature,
hold knob
handle firmly and move the tooth a notch
counterclockwise.
Each notch equals
about 20°F
(11 "C).
Tighten
the locking screws and replace
the control knob.
To lower
Broiling
The broiler drawer is located below the oven
door. Always
broil with the oven door
closed.
1. Pull the broiler drawer open and tilt the
door panel down.
2. Place broiler pan grid
so grease
can drain
down ribbing and through slots into lower
part of the broiler pan. See picture.
3. Before the broiler
is turned
on, place food
on broiler pan and position
the broiler pan
at one of the three levels.
4. Close
broiler drawer.
Drain
slot
Rib
Front
Advertisement
