Maintenance - Skil CS4555-00 Owner's Manual

MAINTENANCE

WARNING
battery operated tool with the battery pack inserted is always on and can start accidently.
WARNING
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
WARNING
dusty, also wear a dust mask .
WARNING
WARNING
Chemicals can damage, weaken, or destroy plastic, which may result in serious personal
injury.
Cleaning
After each use, clean debris from the chain and guide bar with a soft brush. Wipe the chain
•
saw surface with a clean cloth moistened with a mild soap solution.
Remove the side cover, and then use a soft brush to remove debris from the guide bar, saw
•
chain, sprocket and side cover.
Always clean out wood chips, saw dust, and dirt from the guide bar groove when replacing
•
the saw chain.
Replacing the Bar and Chain
WARNING
injury.
WARNING
WARNING
maintenance to the chain.
NOTICE: When replacing the guide bar and chain, always use the specified bar and chain
combination listed in the later section: "Recommended Bar and Chain for this Chain Saw".
To avoid serious personal injury, remove the battery pack from the
chain saw before inspecting, cleaning, or performing maintenance . A
When servicing, use only identical replacement parts . Use of any
other parts could create a hazard or cause product damage .
Always wear safety goggles or safety glasses with side shields
during power tool operation or when blowing dust . If the operation is
When cleaning the chain saw, DO NOT immerse in water or other
liquids.
Do not at any time let brake fluids, gasoline, petroleum-based
products, penetrating oils, etc ., come in contact with plastic parts .
Before performing any maintenance, make sure that the battery pack
is removed . Failure to heed this warning could result in serious personal
Always wear gloves when handling the bar and chain; these
components are sharp and may contain burrs .
Never touch or adjust the chain while the motor is running . The saw
chain is very sharp; always wear protective gloves when performing
25