Step 2: Device C-Cover Keyboard Removal - Microsoft Surface Laptop 3 Removal Manual

Step 2: Device C-cover Keyboard Removal

IMPORTANT:
assembly. The C-cover removal process differs differs between the metal type C-cover and the fabric type
C-cover. Be sure to follow the proper procedure based on the device model and associated C-cover type.
Removal Process (C-cover Keyboard Metal Type)
Preliminary Requirements
IMPORTANT:
Required Tools and Components
· Tools:
5IP (Torx-Plus) driver
o
Anti-static wrist strap (1M Ohm resistance)
o
o Recommended: ESD-safe Battery Cover (13.5" or 15")
Components:
·
o New 5IP screw qty=4
o C-cover (If replacing)
Prerequisite Steps:
· Power off device - Ensure device is powered off and disconnected from a power supply.
· General Safety - Check to make sure that general guidelines and ESD compliance steps are followed prior to
opening device. Refer to Prior to Device Disassembly section
· Remove feet - Follow steps for Procedure-Removal (Non-Skid Foot Pad) section
C-cover removal.
IMPORTANT:
foot sockets prior to C-cover screw removal to avoid the risk of stripping out the C-cover screw(s).
13
Surface Laptop 3 devices are built with either a fabric type or metal type C-cover keyboard
Be sure to follow all special (bolded) notes of caution within each process section.
Be sure that all foot adhesive remains have been removed from the bottom device case
(page 11) for details.
X22-19688-01
(page 12) prior to