Canon WFT-E2 Instruction Manual

Using with eos-1d mark iv, firmware ver. 2.0.0

Hide thumbs Also See for WFT-E2:

Download this manual

Using WFT-E2/E2A (Firmware Ver. 2.0.0) with EOS-1D Mark IV

When using the WFT-E2/E2A (firmware ver. 2.0.0) with an EOS-1D Mark IV, you can use two

additional functions not mentioned in the original WFT-E2/E2A instruction manual. Below,

instructions for these new functions are described with reference to information in the WFT-E2/

E2A manual.

Wi-Fi Protected Setup (WPS) compatibility

The firmware enables easy access to WPS-compatible wireless LAN access points.

Choosing [Wireless LAN] in "Selecting the LAN Type" (p.14 of the manual) will display the

following screen ([Wireless LAN setup method]).

Selecting [WPS (PCB mode)] or [WPS (PIN mode)] makes it easy to access WPS-

compatible wireless LAN access points. For details, refer to "WPS Connection (PBC Mode)"

and "WPS Connection (PIN Mode)" on pages 3 and 4 below.

Note that selecting [Connect with wizard] enables you to complete the wireless LAN

settings as usual.

After the WPS connection is established, the following [Network] screen is displayed.

Subsequent instructions are continued on p.16 of the transmitter manual.

Page 1 Using WFT-E2/E2A (Firmware Ver. 2.0.0) with EOS-1D Mark IV When using the WFT-E2/E2A (firmware ver. 2.0.0) with an EOS-1D Mark IV, you can use two additional functions not mentioned in the original WFT-E2/E2A instruction manual. Below, instructions for these new functions are described with reference to information in the WFT-E2/ E2A manual.
Page 2 When using the transmitter with an EOS-1D Mark III or EOS-1Ds Mark III, you can update the settings identification to match the EOS-1D Mark IV settings ([FTP trans.], [EOSUtility], [WFTserver], and [WFT account]) by updating the EOS-1D Mark III or EOS-1Ds Mark III firmware to a version compatible with the WFT-E2 II.
Page 3 WPS Connection (PBC Mode) This is a connection mode that can be used with a wireless LAN terminal compatible with Wi-Fi Protected Setup (WPS). Pushbutton Connection mode (PBC mode) makes it easy to establish a connection between the camera and the wireless LAN terminal by pressing the WPS button on the wireless LAN terminal.
Page 4 Establish a connection with the wireless LAN terminal. Select [OK] and press <0> to establish a connection with the wireless LAN terminal. When the connection with the wireless LAN terminal is established, the [Network] screen is displayed. CT1-7841E-000 © CANON INC. 2009...

Wft-e2a