Royal Lounge 260 Instructions

Thank you for purchasing your new Lounge 260 awning. By following the below instructions your awning will enable
Lounge 260 Awning Instructions
Parts Included:
Please ensure that all of the parts listed below are
present before attempting to erect your awning
Flysheet
•
• 2 Steel front leg poles
1 Steel curved front pole
•
3 Steel roof poles
•
• 2 Storm straps
Draft Skirt
•
Tent pegs
•
Erecting your Awning:
Start by sliding the awning beading into the channel on the caravan, ensuring that it is on the horizontal section. Insert the
curved front pole into the sleeve on the front of the awning (Fig 1). Then attach the front two legs to the curved front pole,
inserting the pins on the base of the awning into the poles (Fig 2). The pin is on an adjustable strap that can be loosened and
then re-tightened once the pin has been inserted.
Once this has been done insert the centre roof pole with the black stopper resting against the side nearest you caravan, you
can subsequently insert the other two roof support poles on either side of the central one. Once this step has been completed
you can insert the two back legs; inserting the pin into the ground.
Once all poles have been inserted you can then peg down your awning, adjusting the guy lines as necessary.
Note: When inserting your pegs always ensure that they are set at a 45° ° ° ° angle away from your awning (Figure 3). Always use
a mallet to insert your pegs to avoid bent pegs and injury
you to experience many happy and enjoyable years of caravanning.
Before you get started:
Select an area that is clear of debris, trees and rocks and that is as even
as possible to erect your awning on.
Remove your awning from it's storage bag, taking note of how it was
originally packed – this will enable you to pack your awning away in a
similar manner at the end of your trip.
Fig 1 Fig 2 Fig 3