Roku 2 Instruction

ROKU 2 Instruction
Set-Up the Roku 2 Player-
1. Connect the Roku 2 player to your HDTV
by using the supplied HDMI cable.
Connect one end of the cable to the HDMI
port on the back of your ROKU 2 player
and connect the other end of the cable to
an open HDMI port on your HDTV
2. Power on your ROKU 2 player by using
the included power adapter. Plug in the
power adapter to a nearby wall outlet and
connect the other end to the open port on
the back of the Roku 2 player. (There is
no separate on/off switch on the
device.)
3. Make sure the supplied batteries are in
the Roku remote. Become familiar with
the Roku remote buttons ( see attached
diagram)
4. Power on your HDTV and look for a Roku
message to fill the screen. If you see a
blank screen, make sure your TV input
matches the physical connection used to
connect your Roku 2 player to your TV.
Press the INPUT or SOURCE button on
your TV remote until you see the ROKU
screen.
Configure the Wi-Fi connection to the Roku
player
1. Use the arrow and OK buttons on the
Roku remote to select the on-screen
options for connecting your Wi-Fi to the
Roku. The Wi-Fi connection is under
settings on the main Home page.
2. It will take a few moments for the device
to complete connection-depending on
your Wi-Fi Broadband Width and Speed.
Once connected, press the HOME button
on the Roku remote to go back to the
home screen.
REMOTE NOT WORKING? Make sure
batteries are installed properly and if
needed, replace with new batteries
provided. Also, make sure you aim the Roku
remote at the Roku device, not the TV.