Yale 22125 Manual

Yale Professional Remote Controller ( 22125 )
The Remote Controller is used to arm the system in home or away mode, disarm the system and send a panic signal.


I I d d e e n n t t i i f f y y i i n n g g t t h h e e p p
1. BUTTON
Pressing this button will arm the system in away
mode.
2. BUTTON
Pressing and holding this button for three seconds
will send a panic signal, regardless of system
status (armed or disarmed). If the 3 seconds time
is not reached, the Emergency activation will fail.
3. BUTTON
Pressing this button will arm the system in home
mode.
4. BUTTON
Pressing this button will disarm the system. If the
alarm is sounding, pressing this button will stop the alarm (except when the alarm was raised by presing the Remote
Controller's Panic button
5. LED INDICATOR
The LED will flash quickly when the Away Arm, Home Arm and Disarm buttons are pressed.
When the Panic Button is pressed, the LED will first flash slowly for 3 seconds, then flashes quickly for 3 seconds and
turn on for 1 second.
6.
BATTERY COMPARTMENT
The RC-Y7 uses one "CR2032" 3V
the Control Panel along with regular signal transmission, and, the Control Panel will display the status accordingly.
< N O T E >
< N O T E >

When changing battery, after removing the old battery, press any button twice to fully discharge before inserting
new battery.

When a low voltage battery is inserted, the LED will flash 3 times to indicate low battery.


G e t t i n g S t a r t e d
G e t t i n g S t a r t e d
 Remove the battery cover by using a coin to turn it counter-clockwise
 Insert the battery as shown in the diagram, with the unmarked side (negative) of the battery facing down
 Replace the battery cover
 Secure the cover by using a coin to turn clockwise
 Put the Control Panel into Learning Mode (Please refer to the manual of Control Panel).
 Press any button on the Remote Controller.
Please refer to the operation manual of your Yale Control Panel on how to complete the learnign process
a a r r t t s s
225 mAh Lithium battery as its power source.The low battery status will be sent to