Advertisement
【The Rear Panel / 背面面板】
Rear of HG-3105/ HG-3105 背面
5V DC
Power Jack / 電源孔
安裝
Installation /
:
Step 1 / 步驟一:
Use Ethernet Cable to connect any Ethernet port on the switch with network devices (modem or router).
將網路線一端連接到交換器背後的連接埠，再將另一端連接到網路設備(數據機或是路由器)。
Step 2 / 步驟二:
Use Ethernet Cable to connect any Ethernet port on the switch with PC.
將網路線一端連接到交換器背後的連接埠，再將另一端連接到電腦。
Step3 / 步驟三:
Connect the power adapter into the back of the switch, and then power on the unit. After that,
the Power LED will be on, and the Ethernet Speed/ Link/Act LEDs which correspond to the
Ethernet ports linked with PC or device will also be on.
將變壓器連接交換器背面的電源插孔，再插入電源插座。
此時交換器電源燈會亮起，交換器上有連接電腦或網路設備的網路連接埠的對應燈號也會亮起。
常見問題
Q&A /
:
Q:The Power LED is off.
A : The Switch is power off.
Please check whether the power adapter is properly plugged in the socket.
If it is well plugged, make sure the socket is on.
Q:Ethernet Speed/ Link/Act LED is not lit for a connected device.
A : Please make sure the cable connectors are securely plugged in at the switch and the device.
Also, check the connected device is turned on and installed correctly.
問: 電源燈未亮
答: 電源燈未亮則無電源，請確認變壓器是否正確接再電源插座上。
若已接上插座，確定電源插座是在開啟狀態。
檢查變壓器是否已連接至交換器電源插孔，並確認沒有鬆脫。
問：網路接線連接埠的燈沒有亮
答：請確定連接交換器的電腦或是網路設備已開啟。
確定網路線有正確連接在交換器和電腦或是網路設備上。
Rear of HG-3108 / HG-3108背面
10/100/1000 Mbps Ethernet Ports
10/100/1000 Mbps 乙太網路連接埠
Advertisement
