Sound Equalization; Using A Rear View Camera - JVC KW-AVX830 Instructions Manual

Sound equalization

~
Ÿ
Select a sound mode.
Equalizer
Flat
Natural
Dynamic
Vocal Boost
Bass Boost
Super Bass
Back Edit
Move to other six sound modes
• You can also change the sound mode by
pressing the short cut icon. (
Storing your own adjustments
You can store your adjustments into <User1>,
<User2>, and <User3>.
1
Repeat steps ~ and Ÿ, then...
Back Edit

Using a rear view camera

• To use a rear view camera, the REVERSE GEAR SIGNAL lead connection is required. For connecting a rear view
camera, see the Installation/Connection Manual.
• For KW-AVX730: Make sure to select <Camera> for <AV Input> setting. (
Displaying the rear view screen
The rear view screen is displayed when you shift the
gear to the reverse (R) position.
• While the pictures through the camera are shown on
the screen, no message will be displayed.
Equalizer
60 100 1.0k 2.5k 10k 15k
Exit
7)
Exit
2
Select the band (1), frequency (2),
adjust the volume (3), then adjust the
quality factor to make the sound natural
(4).
Frequency
User Store
User1
User2
User3
Freq 60 Hz
Q 1.0
Back
Quality factor*
3
Select <User1>, <User2>, or <User3> to
store the adjustment.
The adjustment is stored.
• When <High Pass Filter> is set to <On>, the
setting of low band is invalid. Select <Through> to
activate the low band setting. (
* When adjusting "High" band, the quality factor value is
fixed.
• When you perform one of the following operations,
the rear view screen is cleared.
– Press DISP.
– Shifting the gear to another position other than the
reverse (R) position.
28
Band
Low Mid High
60 100 1.0k 2.5k 10k 15k
Exit
34)
32)