Refresh Battery - Panasonic TOUGHBOOK CF-07 Tips For Use

Important Battery Tips

5. Refresh Battery

The battery pack has a function for measuring, storing, and learning about battery capacity. Using this function
properly to accurately display remaining battery capacity requires that the battery be fully charged (charged to 100%),
then fully discharged, and then fully charged again.
This procedure should be performed once after you purchase the computer/wireless display. As you use the battery
pack over a long period of time, the remaining capacity display may become inaccurate due to battery deterioration
and other factors. If this is the case, the procedure described below should be performed again.
<For the computer>
1
Attach the battery pack and connect the AC adaptor
Remove all peripherals (except for the battery pack and AC adaptor).
2
Use the "Refresh Battery" utility to fully discharge the battery
1 Run the Setup Utility.
2 Select [Refresh Battery] from [Exit] menu, then press Enter .
3 At the confirmation message, select [Yes], then press Enter .
3
Allow the battery to charge until the battery indicator turns green
<For the wireless display>
1
Attach the battery pack and connect the AC adaptor
2
Use the "Refresh Battery" utility to fully discharge the battery
1 Press MENU button to display the setting menus.
2 Select [Refresh Battery] from [Battery] menu.
3 At the confirmation message, select [Yes].
3
Allow the battery to charge until the battery indicator turns green