Husqvarna 340i Workshop Manual page 21

11. Disconnect the connector for the chain brake sensor
(A).
A
C
B
D
12. Remove the wire harness (B), the motor (C), the
control unit (D) and the battery connector (E) from
the crankcase half.
13. Disconnect the user interface connector from the
control unit.
14. Remove the 3 screws and disconnect the motor
cables from the control unit.
1435 - 001 - 11.06.2020
E
15. Disconnect the communication cable (A) from the
control unit.
B
A
16. Remove the 2 screws (B) and the battery connector
from the control unit.
5.7.2 To install the motor, control unit and battery
connector
1. Install the battery connector cables with the 2
screws (A).
A
B
2. Connect the communication cable (B) to the control
unit.
3. Install the motor cables on the control unit with the 3
screws.
Repair instructions - 21