Husqvarna 129C Workshop Manual page 54

Repair Instructions
3
Fit the crankshaft in the clutch side's crankcase
half. Lubricate the stub axle with a few drops of oil
and carefully slide in the crankshaft in the ball-
bearing so that the sealing ring is not damaged by
the shoulder on the stub axle. See figure 78.
4
Place a new crankcase gasket on the crankcase
and secure if necessary with a little grease.
Lubricate the tapered crankshaft journal with a few
drops of oil and slide the flywheel side's crankcase
half in position.
Tighten the 3 crankcase screws crosswise. See
figure 79.
Check that the crankshaft can rotate easily.
5
Assemble the piston on the connecting rod.
Place a distance washer on each side of the
needle bearing.
Turn the washers so that the countersink faces the
needle bearing.
Check that the piston is turned so the arrow points
towards the exhaust port.
Make sure that the gudgeon pin circlips are seated
correctly in the slots.
6
Attach the flywheel and drive disc cup to the
crankshaft. See figure 80.
54
- English
Fig 78
Fig 79
Fig 80