Advertisement
Introduction
The Midas M® is a Fixed Extractive Single Point with 4-in 1 Multi Gas
Detector that draws a sample locally or from a remote point to a sensor
cartridge that is located inside the detector's chassis. A wide range of toxic,
flammable and oxygen gas sensor cartridges are available that enable
detection of gases used or generated in the Semiconductor and other
manufacturing industries.
NOTE: Midas M is shipped from the factory with the security function
disabled. We strongly recommend enabling this function for safe use of
the detector. To enable it, select Set up > Security and type an 8 character
password.
Safety
Failure to observe the following precautions can cause injury to persons or
damage to property:
•
To minimize the risk of electrostatic charging, provide a suitable
ground connection, and install the equipment in such a way that no
accidental discharges occur.
•
When Midas M reaches the end of its life, it should be disposed of by
local regulations.
•
Do not use cleaning solvents or abrasives to clean the gas detector.
•
Do not attempt to modify the product in any way from the manufactur-
er's design or specification. Warranty will be void and malfunction of
the gas detector may result.
•
Use only genuine spare parts and accessories with Midas M. Malfunc-
tion may result if non-standard parts are used.
•
Midas M is suitable for ordinary locations only and must not be in-
stalled in hazardous locations.
•
Installation must be by the recognized standards of the appropriate
authority in the country concerned. For Europe, see EN60079 14,
EN60079 29 2, and EN61241 14. For installations in North America,
the National Electrical Code (NFPA 70) should be strictly observed. All
the appropriate local and national regulations should be observed.
CAUTION
Advertisement
