DeLonghi TRRS2715EBKCA Instructions For Use Manual page 13

play will show symbol. If the selected temperature is
much higher than the actual room temperature, the appli-
ance will start automatically to heat the room and select the
most convenient power level (MAX-MED-MIN-OFF).
If MAX power level has been selected using the
ton, the appliance will cycle between: MAX-MED-MIN-OFF.
If MED power level has been selected, the appliance will cycle
between: MED-MIN-OFF.
If MIN power level has been selected, the appliance will cycle
between: MIN-OFF.
Working indicator
The symbol indicates the heating status by means of its
colors.
RED: the unit is heating at the maximum power.
ORANGE: the unit is heating at the medium power.
GREEN: the unit is heating at the minimum power.
symbol absent: the unit is not heating.
Key lock
In order to avoid accidental operation, you can lock the con-
trols using the keylock function. To activate this function dur-
ing ON mode, press buttons + and - together for at least 3
seconds. The display shows the symbol
signal will be emitted. To deactivate the function proceed in
the same way.
Timer function
This function can be activated in two different ways.
Delayed start: With the appliance in standby mode, press
the timer button (G) . The hours left before the appliance
comes on is displayed together with the
symbol flashing (see fig. 3). Change the hours using the +
and - buttons, then wait a few seconds for the program to
be stored.
The display will return to off and the
When the programmed time has elapsed, the appliance will
come on with the previous settings.
Fig. 3
Delayed stop: with the appliance ON, press the timer but-
ton . The hours left before the appliance goes to standby
mode, the power level and the function selected are dis-
played together with the
(see fig. 3). Change the hours using the + and - buttons, then
wait a few seconds for the program to be stored.
but- The current settings and
of the set time the appliance switches to standby mode au-
tomatically. To go back to operating without the timer, press
the timer button twice. The timer symbol
from the display.
Change of the temperature scale
The display can show the temperature in both °F and °C.
To select the desired temperature scale, when the unit is in
standby position, press and hold the "+" and "ECO" keys for at
least 10 seconds, then release.
and an acoustic
The change of scale will be indicated by two short beeps.
Brightness of the display
The appliance allows different brightness settings for the
display. The highest is active when any key button is pressed.
After a few seconds of keyboard inactivity, the brightness will
decrease to the operating brightness level. This lower level
can be adjusted in this way:
symbol and "h"
-
symbols remains on.
-
-
Alarms
The appliance has a diagnostic system that makes it possible
13
symbol and "h" symbol flashing
symbol are displayed. At the end
Please note: the time is settable from 0.5 to 24 hours.
Fig. 3
with the appliance in ON mode, press the ECO button for
5 seconds and the display will show (see fig. 4):
Fig. 4
With the + and - buttons it is possible to select the de-
sired brightness.
After 5 seconds without pressing any buttons, the
brightness level will be memorized and the operating
conditions will be the same ones previously set.
disappears