6. Installing
This section describes basic installation for the Unit.
6.1. Mounting Configuration
The Unit can be mounted with OMT or the waveguide filter of the satellite
antenna.
When mounting on the OMT or the waveguide filter, follow the following
caution:
When mounting with the OMT or the waveguide filter, follow the following
steps:
Step 1:
NJT5669/70/75/77 series Instruction Manual
DO NOT block the fins.
Normally the Unit should be mounted with long fins face up.
Verify that the groove on the waveguide flange of the Unit for the
o-ring is clean.
Insert the supplied o-ring (gasket) the groove as shown in a figure
below.
Insaeting O-ring
IM-T5669 Rev.01
Page 18