BWL-1S-10/14 outdoor module
B
Aperture for condensate drain pipe
(Caution: Do not obstruct the aperture
in the condensate pan)
C
Overflow outlet
E
Adhesive aluminium tape
D
End of unheated area on drain heater
Note on 6:
•
The end of the unheated area must be positioned at point D.
•
Only use cable ties to secure the unheated area of the drain heater.
•
The drain heater is secured at the bottom of the left-hand motor support.
Route the heated area of the drain heater as close as possible to apertures B and C on the floor of the
•
condensate pan.
•
When doing so, secure the drain heater to the floor in 2 places using adhesive aluminium tape.
46
GB
BWL-1S-10/14 outdoor module
6.
E
E
3064055_201508