Changing The Control Settings; Adjusting The Refrigerator Shelves - Whirlpool ED20ZK Use And Care Manual

Changing the control settings
If you need to adjust temperatures in refrigerator
or freezer, use the settings listed in the chart
below as a guide. If you have questions, call our
Consumer Assistance Center number. (See
page 23.)
l
Adjust the Refrigerator Control first.
l
Wait at least 24 hours between adjustments.
l
Then adjust the Freezer Control if needed.
CONDITION:
If Refrigerator
Section is
TOO WARM
If Freezer
Section is
TOO WARM
If Refrigerator
Section is
TOO COLD
REASON:
Door opened often
Large amount of food added
Room temperature too warm
Door opened often
Large amount of food added
Very cold room temperature
(can't cycle often enough)
Controls not set correctly
for your conditions
RECOMMENDED
CONTROL SETTINGS:
Refrigerator
Freezer i
Refrigerator 3
Freezer C
Refrigerator 2
Freezer B
If ICE isn't
MADE FAST
ENOUGH
If BOTH
SECTIONS
are TOO WARM
Heavy ice usage
Very cold room temperature
(can't cycle often enough)
Door opened often
Large amount of food added
Very warm or very cold room
temperatures
Refrigerator 3
Freezer C
Refrigerator
Freezer
ii
Adjusting the refrigerator shelves
Shelves can be adjusted to match the way you
use your refrigerator. Glass shelves are strong
enough to hold bottles, milk and other heavy food
items.
To remove shelves:
1. Remove items from shelf.
2. Tilt shelf up at front.
3. Lift shelf up at back.
4. Pull shelf straight out.
To replace shelves:
1. Guide the rear hooks into the slots in the shelf
supports.
2. Tilt up front of shelf until hooks drop into slots.
3. Lower front of shelf to level position.
NOTE: The above instructions apply to all
models in this manual (ED20PK with glass
shelves and ED20ZK and ED22ZR with wire
shelves).
8