Cycle Status Indicators; Drying System; Overfill Protection Float - Whirlpool TUD8700S Use And Care Manual

Whirlpool dishwasher user manual
Table of Contents

Advertisement

Lock
Use the lock to avoid unintended use of the dishwasher. You can
also use the lock feature to avoid unintended cycle or option
changes during a cycle.
When the lock is lit, all buttons are disabled.
NOTES:
The dishwasher door can be opened while the controls are
locked.
You can turn on the lock while the dishwasher is running. If
you open the door, unlock the controls and press START/
RESUME to restart. You can lock controls again, if desired.
To turn on the lock
Press and hold HEATED DRY for 4 seconds. The lock glows.
If you press any pad while your dishwasher is locked, the light
flashes 3 times and the selection is ignored.
To turn off the lock
Press and hold HEATED DRY for 4 seconds. The light turns off.
Delay start
Select this option to run your dishwasher at a later time or during
off-peak hours. You can add items to the load anytime during the
delay countdown. After adding items, close the door firmly until it
latches. The delay countdown will not continue if the door is not
latched. Press START/RESUME. If the door is unlatched, the
Start/Resume indicator flashes. The delay countdown stops until
you latch the door and press START/RESUME.
To delay the start
1. Press DELAY for a 4-hour delay. The light above the Delay
pad glows.
2. Select a wash cycle and option or skip to Step 3 to use the
cycle and options selected for last cycle.
3. Press START/RESUME. (The door must be closed.) The delay
countdown starts, and the cycle will begin after 4 hours.
NOTES:
To cancel the delay and cycle, press CANCEL/DRAIN.
To cancel the delay and start the cycle, press START/
RESUME.

Cycle Status Indicators

Follow the progress of your dishwasher with the Cycle Status
Indicators. Clean glows when a cycle is finished. The light turns
off when you open the door or press CANCEL/DRAIN.
Washing
Washing glows while the dishwasher is washing or rinsing the
dishes.
Drying
Drying glows while the dishwasher is drying your dishes.
Clean
Clean glows when a cycle is finished. The light turns off when you
open the door or press CANCEL/DRAIN.

Drying System

During drying, you can see steam escaping through the vent at
the upper left corner of the door. This is normal as the heat dries
your dishes.
IMPORTANT: The vapor is hot. Do not touch the vent
during drying.

Overfill Protection Float

The overfill protection float (in the front right corner of the
dishwasher tub) keeps the dishwasher from overfilling. It must be
in place for the dishwasher to operate.
Check under the float for objects that may keep the protector
from moving up or down.
13

Advertisement

Table of Contents
loading

Table of Contents