Whirlpool TUD2000 Use And Care Manual page 8

Changing a cycle setting
(model series TUDSOOO, TlJD5000, TUD7000)
You can change
a
setting anytime during any cycle.
1.
Lift up on the door latch to unlatch the
door
and
stop the cycle.
2. Turn the Cycle Control knob clockwise to
the cycle you want.
3. Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
pages
11
and 12.
4.
NOTE:
Turning the Cycle Control knob
may cause the covered section of the
deiergent dispenser to open. Be sure to fill
the covered section,
and close
the cover, if
the cycle uses detergent in both sections.
CkBse and latch the door. The dishwasher
wil, automatically start the new cycle.
Changing an option
You can change an option anytime during a cycle. To change the selected option(s):
Selectlon varies
with models
For models with seven buttons:
1.
Push the RESET OPTIONS button.
2. Push an Option Selector button for each
desired option.
Canceling a cycle
You can cancel a setting anytime during any cycle.
1. Turn the Cycle Control knob slowly 2. LIZ: the dishwasher drain completely.
clockwise to the drain portion of the wash
or rinse. You will hear water draining
3. Lii: up on the door latch to unlatch the door.
when you have
advanced
to the proper
4. Tul-n the Cycle Control knob clockwise to
location.
po nt to OFF.
8