Prologic Ii Setup; Other Setup Functions - Adcom GTP-860II Owner's Manual

The mode option sets the default
surround mode to be used with
each source. The options are DOLBY
DIGITAL, DTS, PRO LOGIC II-C/M/P ,
HALL, STEREO, and 5 CH STEREO. The
available choices in each of the fields
can be selected with the left or right
arrow buttons on the remote; confirm
the choice with the select button.

3.6 ProLogic II Setup

Dolby ProLogic II is a surround mode
that can be used to generate sur-
round sound from stereo program
material. The settings below can be
PROLOGIC II SETUP
CENTER WIDTH: 3
DIMENSION: 0
RETURN TO SETUP
used to optimize the surround sound
listening experience when you are
CHANNEL TEST
using ProLogic II.
LEFT:
DIMENSION = This parameter is used CENTER:
RIGHT:
when listening in ProLogic II Music
REAR R :
mode, it changes the level balance
BACK R :
from front speakers to back speakers,
BACK L :
REAR L :
much the same way the fader adjust
SUB:
works in some car audio systems. The
value can be varied from -3 (more
RETURN TO SETUP
sound level from the rear)to 3(more
sound level from the front).
CENTER WIDTH = This adjustment
is used when listening to ProLogic II
music mode. It changes the amount
of sound coming out of the center
speaker. Adjust this parameter for
best over all imaging between the
front left/right and center speaker.
As the value in increased, the appa-
rant image width of the sound stage
will increase.
| ADCOM GTP-860 II Owner's Manual
26
3.7 Other Setup
Functions
The GTP-860 II also has certain func-
tions that can be accessed by using
multiple front panel buttons pressed
simultaneously.
Reset 1: Restore factory default set-
tings and NTSC video = FM/AM button
+ video 1 button
Reset 2: Restore factory default set-
tings and Pal video = FM/AM button +
video 2
Video Mode switch (system inter-
change): Change unit between NTSC
and Pal video = FM/AM button + CD
button
Frequency interchange: Changes the
unit AM stepping frequency between
US (10kHz) and Europe (9kHz) = FM/
AM button + tape monitor button
VFD segment test: lights up all seg-
ments of the front panel display =
memory button + AM button + video
4 button. Press any key to exit test
mode.
0dB
1dB
Display software version: shows cur-
0dB
rent version of software on the front
0dB
panel display = memory button + FM
0dB
button + video 5 button. Press any
0dB
0dB
key to exit.
0dB
Program EEPROM: Programs and
restores the system memory to facto-
ry preset condition = memory button
+ CD button + surround mode button.
Press any key when programming is
complete.